EnSlaved – sectioning the frame on my Nissan Hardbody

Made some progress over the last few day. I’m happy to say this is going way better then I expected.

D21 frame with a section cut out

D21 right side frame sectioned

I decided to cut this side of the frame in two parts. Thus leaving the rear cross member in place. I don’t think it was really necessary but it made me feel better. For this cut I used a grinder to cut a small slit in each side of the frame rails allowing a sawzall blade to fit through. After that I simply cut with a sawsall blade. Only one blade. It cut way easier then expected.

Continue reading EnSlaved – sectioning the frame on my Nissan Hardbody